Mellanox MLNX-OS®Command Reference Guide for SX1018HP Ethernet Managed Blade Switch

Rev 1.6.2
Mellanox Technologies
31
speed
speed <speed>
no speed
Sets the interface speed.
The no form of the command resets the speed setting for this interface to its default
value.
Syntax Description speed Sets the speed of the interface. The following are the
possible values:
• 10 - fixed to 10Mbps
• 100 - fixed to 1000Mbps
• 1000 - fixed to 1000Mbps
• auto - auto speed sensing (10/100/1000Mbps)
Default auto
Modes/Context Config Interface Management
History 3.1.0000
Role admin
Example
switch (config interface mgmt0) # speed auto
switch (config interface mgmt0) # show interfaces mgmt0
Interface mgmt0 state
Admin up: yes
Link up: yes
IP address: 172.30.2.2
Netmask: 255.255.0.0
Secondary address: 9.9.9.9/32 (alias: 'mgmt0:2')
IPv6 enabled: yes
Autoconf enabled: no
Autoconf route: yes
Autoconf privacy: no
IPv6 addresses: 1
IPv6 address: fe80::202:c9ff:fe5e:a5d8/64
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface ifindex: 2
Interface source: physical
MTU: 1500
HW address: 00:02:C9:5E:A5:D8
Comment:
RX bytes: 2970074221 TX bytes: 468579522
RX packets: 44983023 TX packets: 1390539
RX mcast packets: 0 TX discards: 0
RX discards: 0 TX errors: 0
RX errors: 0 TX overruns: 0
RX overruns: 0 TX carrier: 0
RX frame: 0 TX collisions: 0
TX queue len: 1000
switch (config interface mgmt0) #