Mellanox MLNX-OS®Command Reference Guide for SX1018HP Ethernet Managed Blade Switch

Rev 1.6.2
Mellanox Technologies
313
lacp (interface)
lacp {rate fast | port-priority <1-65535>}
no lacp {rate fast | port-priority}
Configures the LACP interface parameters.
The no form of the command sets the LACP interface configuration to default.
Syntax Description rate fast Sets LACP PDUs on the port to be in fast (1 second) or
slow rate. (30 seconds).
1-65535 LACP port-priority.
Default rate - slow (30 seconds)
port-priority 32768
Modes/Context Config
History 3.1.1400
Role admin
Example
switch (config)# lacp rate fast
switch (config)# show lacp interfaces ethernet 1/7
Port : 1/7
-------------
Port State = Down
Channel Group : 1
Pseudo port-channel = Po1
LACP port-priority = 32768
LACP Rate = Slow
LACP Activity : Passive
LACP Timeout : Short
Aggregation State : Aggregation, Defaulted,
LACP Port Admin Oper Port Port
Port State Priority Key Key Number State
-------------------------------------------------------------------
1/7 Down 128 1 1 0x7 0x0
switch (config)#
Related Commands
Note Configuring LACP rate (fast or slow) will configure the peer port to send (fast or
slow), it does not make any affect on the local port LACP rate.