Mellanox MLNX-OS®Command Reference Guide for SX1018HP Ethernet Managed Blade Switch

Rev 1.6.2

Mellanox Technologies

ipv6 enable

no ipv6 enable

Enables all IPv6 addressing for this interface.

The no form of the command disables all IPv6 addressing for this interface.

Syntax Description N/A

Default IPv6 addressing is disabled

Modes/Context Config Interface Management

History 3.1.0000

Role admin

Example

switch (config interface mgmt0) # ipv6 enable

switch (config interface mgmt0) # show interfaces mgmt0

Interface mgmt0 state

Admin up: yes

Link up: yes

IP address: 172.30.2.2

Netmask: 255.255.0.0

IPv6 enabled: yes

Autoconf enabled: no

Autoconf route: yes

Autoconf privacy: no

IPv6 addresses: 1

IPv6 address: fe80::202:c9ff:fe5e:a5d8/64

Speed: 1000Mb/s (auto)

Duplex: full (auto)

Interface type: ethernet

Interface ifindex: 2

Interface source: physical

MTU: 1500

HW address: 00:02:C9:5E:A5:D8

Comment: my-interface

RX bytes: 962067812 TX bytes: 40658219

RX packets: 3738865 TX packets: 142345

RX mcast packets: 0 TX discards: 0

RX discards: 0 TX errors: 0

RX errors: 0 TX overruns: 0

RX overruns: 0 TX carrier: 0

RX frame: 0 TX collisions: 0

TX queue len: 1000

switch (config interface mgmt0) #