Mellanox MLNX-OS®Command Reference Guide for SX1018HP Ethernet Managed Blade Switch

Rev 1.6.2

Mellanox Technologies

Example

switch (config interface mgmt0) # ipv6 fe80::202:c9ff:fe5e:a5d8/64

switch (config interface mgmt0) # show interfaces mgmt0

Interface mgmt0 state

Admin up: yes

Link up: yes

IP address: 172.30.2.2

Netmask: 255.255.0.0

IPv6 enabled: yes

Autoconf enabled: no

Autoconf route: yes

Autoconf privacy: no

IPv6 addresses: 1

IPv6 address: fe80::202:c9ff:fe5e:a5d8/64

Speed: 1000Mb/s (auto)

Duplex: full (auto)

Interface type: ethernet

Interface ifindex: 2

Interface source: physical

MTU: 1500

HW address: 00:02:C9:5E:A5:D8

Comment: my-interface

RX bytes: 962067812 TX bytes: 40658219

RX packets: 3738865 TX packets: 142345

RX mcast packets: 0 TX discards: 0

RX discards: 0 TX errors: 0

RX errors: 0 TX overruns: 0

RX overruns: 0 TX carrier: 0

RX frame: 0 TX collisions: 0

TX queue len: 1000

switch (config interface mgmt0) #

Related Commands ipv6 enable

show interface <ifname>

Note

• Unlike IPv4, IPv6 can have multiple IPv6 addresses on a given interface

• For Ethernet, the default interface identifier is a 64-bit long modified EUI-64, which is

based on the MAC address of the interface