SX1018HP Ethernet Managed Blade Switch User Guide for HP c-Class BladeSystems
SX1018HP Ethernet Managed Blade Switch HW User Manual Rev 1.0
Mellanox Technologies
15
Figure 9: QSFP+ Cable Connector
2.2.1 Installing a Cable in the Mellanox SX1018HP Ethernet Switch
To install a cable in the Mellanox SX1018HP Ethernet Switch, follow these steps:
1. Align the cable QSFP+ connector with the Mellanox SX1018HP Ethernet Switch port ( Fig-
ure 10).
2. Insert the QSFP+ connector into the Mellanox SX1018HP Ethernet Switch port (Figure 10)
until it is fully engaged and locked.
Figure 10: Cable Installation
Table 4 - QSFP Cable Connector Description
1 Cable
2 QSFP+ connector release pull tab
3 QSFP+ connector
The cables are not included in this kit and must be purchased separately.
1 QSFP+ connector
2 Mellanox SX1018HP Ethernet Switch - port # 1
3 Cable
72mm
max
18.35
mm
1
2
3