SX1018HP Ethernet Managed Blade Switch User Guide for HP c-Class BladeSystems

Configuring the Switch the First TimeRev 1.0

Mellanox Technologies

Step 6. Before attempting a remote (for example, SSH) connection to the switch, check the mgmt0

interface configuration. Specifically, verify the existence of an IP address. To check the current

mgmt0 configuration, enter the following commands:

The following is an example of the output:

Table 8 - Configuration Wizard Session - Zeroconf Configuration

Wizard Session Display - IP Zeroconf Configuration (Example)

Mellanox configuration wizard

Do you want to use the wizard for initial configuration? yes

Step 1: Hostname? [switch]

Step 2: Use DHCP on mgmt0 interface? [yes] no

Step 3: Use zeroconf on mgmt0 interface? [no] yes

Step 4: Default gateway? [For example:192.168.10.1]

Step 5: Primary DNS server?

Step 6: Domain name?

Step 7: Enable IPv6? [yes]

Step 8: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no]

Step 9: Admin password (Enter to leave unchanged)?

To change an answer, enter the step number to return to.

Otherwise hit <enter> to save changes and exit.

Choice:

Configuration changes saved.

To return to the wizard from the CLI, enter the "configuration jump-start"

command from configure mode. Launching CLI...

switch>

switch > enable

switch # configure terminal

switch (config)# show interfaces mgmt0

Interface mgmt0 state

Admin up: yes

Link up: yes

IP address: 192.168.10.4

Netmask: 255.255.255.0

Speed: 1000Mb/s (auto)

Duplex: full (auto)

Interface type: ethernet