User Manual

● X = 2: tray 2
● X = 3: tray 3
● X = 4: tray 4
● X = 5: tray 5
The overfilled condition is sensed by the stack surface sensor when the tray is first closed. If the
stack surface sensor does not move down (because the tray is too full), the overfilled message will be
displayed and the tray will not be available for printing.
Recommended action
1. Open the tray and remove paper until the tray filled indicators can be seen.
2. Close the tray.
3. Make sure that all the connections from the DCC to the paper pick-up assembly and lifter drive
assembly are fully seated and connected.
4. If the lifter drive assembly was removed or replaced, make sure that the connector on the
assembly is connected correctly and fully seated.
5. If the error persists, perform a tray bin sensor test for the paper stack sensor of the specified tray.
Replace sensors if necessary.
6. If the error persists, replace the paper pick-up assembly.
Part numbers:
Assembly, paper-pickup RM1-5919-000CN
Assembly, paper-pickup (1x500-sheet paper feeder, 2,500-
sheet paper feeder HCI)
RM2-0341-000CN
Tray <X> [type] [size]
The paper in the specified tray is detected as the specified size and type.
The custom switch was not changed.
Recommended action
■
If the paper is a custom size or type, change the custom-size switch on the tray as necessary.
Type mismatch Tray <x>
The specified tray contains a paper type that does not match the configured type.
Recommended action
The specified tray will not be used until this condition is addressed. Printing can continue from other
trays.
1. Load the correct paper in the specified tray.
2. On the printer control panel, make sure the paper type loaded in the tray matches the specified
setting for the tray.
350 Chapter 7 Alphabetical control panel messages