Installation Instructions

2. Use the hose wrench, included in the kit contents, to tighten an
additional 2 flats.
(Optional) Shortening the hoses
1. Using the L-key (supplied with this kit), remove the four M6
screws on the clam shell clamp, turning each screw one turn
until they are all equally loose and can be removed. Retain
screws to reinsert later.
2. Remove the clam shell clamp from around the hose and remove
the swivel nut from the end of the hose.
3. Using a hacksaw, cut the end of the hose to the desired length.
4. Insert the swivel nut into the end of the hose and then replace
the clam shell clamp around the hose.
NOTE: The shorter screws do not reach the threads of
the clam shell until the clam shell is tightened.
Therefore, you must use the longer screws first to tighten
and secure the clam shell, and then you can replace the
longer screws with the original shorter screws.
5. Insert the four longer M6 screws included in the kit to secure
the clam shell clamp around the hose.
6. Using the L-key, tighten the longer M6 screws one turn at a
time, tightening all four screws evenly. The clamp must be tight
enough for the four shorter M6 screws to reach.