Installation Instructions

7. One hole at a time, replace the longer M6 screws with the
original shorter M6 screws.
8. When you have replaced all four longer M6 screws with the
original shorter M6 screws, use the L-key to fully tighten each
screw.
Attaching the main hose to the
facility water line
1. Attach the main hoses to the facility water lines, and hand
tighten the swivel nut.
2. Use the hose wrench, included in the kit contents, to tighten an
additional 2 flats.
(Optional) Attaching the warning
label to the hose
NOTE: The warning label reminds you:
Water will drain when
disconnected from the facility
piping.
If your hoses require additional insulation, attach the warning labels
to the insulated hoses.