Command Reference Guide

SNMP Commands
CLI Command Reference
September 2014 Page 103
HP Moonshot Switch Module CLI Command Reference
snmp trap link-status all
This command enables link status traps for all interfaces.
no snmp trap link-status all
This command disables link status traps for all interfaces.
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only if the
Link Trap flag setting associated with the port is enabled. See “show snmp” on page 111.
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent when a
user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing terminal interface session.
Format
snmp trap link-status all
Mode Global Config
Format
no snmp trap link-status all
Mode Global Config
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config
Format
no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format
snmp-server enable traps multiusers
Mode Global Config