Command Reference Guide

SNMP Commands
CLI Command Reference
September 2014 Page 104
HP Moonshot Switch Module CLI Command Reference
no snmp-server enable traps multiusers
This command disables Multiple User traps.
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
snmp-server engineID local
This command configures the SNMP engine ID on the local device.
Format
no snmp-server enable traps multiusers
Mode Global Config
Default enabled
Format
snmp-server enable traps stpmode
Mode Global Config
Format
no snmp-server enable traps stpmode
Mode Global Config
Default The engineID is configured automatically, based on the device MAC address.
Format
snmp-server engineID local {engineid-string|default}
Mode Global Config
Parameter Description
engineid-string A hexadecimal string identifying the engine-id, used for localizing configuration. Engine-id
must be an even length in the range of 6 to 32 hexadecimal characters.
default Sets the engine-id to the default string, based on the device MAC address.
Caution! Changing the engine-id will invalidate all SNMP configuration that exists on the box.