Command Reference Guide

SNMP Commands
CLI Command Reference
September 2014 Page 111
HP Moonshot Switch Module CLI Command Reference
show snmp
This command displays the current SNMP configuration.
show snmp engineID
This command displays the currently configured SNMP engineID.
Format
show snmp
Mode Privileged EXEC
Term Definition
Community
Table:
Community-
String
The community string for the entry. This is used by SNMPv1 and SNMPv2
protocols to access the switch.
Community-
Access
The type of access the community has:
•Read only
•Read write
•su
View Name The view this community has access to.
IP Address Access to this community is limited to this IP address.
Community
Group Table:
Community-
String
The community this mapping configures
Group Name The group this community is assigned to.
IP Address The IP address this community is limited to.
Host Table: Target Address The address of the host that traps will be sent to.
Type The type of message that will be sent, either traps or informs.
Community The community traps will be sent to.
Version The version of SNMP the trap will be sent as.
UDP Port The UDP port the trap or inform will be sent to.
Filter name The filter the traps will be limited by for this host.
TO Sec The number of seconds before informs will time out when sending to this
host.
Retries The number of times informs will be sent after timing out.
Format
show snmp engineID
Mode Privileged EXEC
Parameter Description
Local SNMP EnginID The current configuration of the displayed SNMP engineID.