Command Reference Guide

RADIUS Commands
CLI Command Reference
September 2014 Page 115
HP Moonshot Switch Module CLI Command Reference
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In
User Service (RADIUS) server on your network for authentication and accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
radius accounting mode
This command is used to enable the RADIUS accounting function.
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS accounting
function is disabled.
Default disable
Format
authorization network radius
Mode Global Config
Format
no authorization network radius
Mode Global Config
Default disabled
Format
radius accounting mode
Mode Global Config
Format
no radius accounting mode
Mode Global Config