Command Reference Guide

RADIUS Commands
CLI Command Reference
September 2014 Page 119
HP Moonshot Switch Module CLI Command Reference
no radius server msgauth
The no version of this command disables the message authenticator attribute to be used for the specified
RADIUS Authenticating server.
radius server primary
This command specifies a configured server that should be the primary server in the group of servers which
have the same server name. Multiple primary servers can be configured for each number of servers that have
the same name. When the RADIUS client has to perform transactions with an authenticating RADIUS server of
specified name, the client uses the primary server that has the specified server name by default. If the RADIUS
client fails to communicate with the primary server for any reason, the client uses the backup servers
configured with the same server name. These backup servers are identified as the Secondary type.
radius server retransmit
This command configures the global parameter for the RADIUS client that specifies the number of
transmissions of the messages to be made before attempting the fall back server upon unsuccessful
communication with the current RADIUS authenticating server. When the maximum number of retries are
exhausted for the RADIUS accounting server and no response is received, the client does not communicate
with any other server.
Format
no radius server msgauth ipaddr|dnsname
Mode Global Config
Format
radius server primary {ipaddr|dnsname}
Mode Global Config
Field Description
ip addr The IP address of the RADIUS Authenticating server.
dnsname The DNS name of the server.
Default 4
Format
radius server retransmit retries
Mode Global Config
Field Description
retries The maximum number of transmission attempts in the range of 1 to 15.