Command Reference Guide

RADIUS Commands
CLI Command Reference
September 2014 Page 120
HP Moonshot Switch Module CLI Command Reference
no radius server retransmit
The no version of this command sets the value of this global parameter to the default value.
radius source-interface
Use this command to specify the physical or logical interface to use as the RADIUS client source interface
(Source IP address). If configured, the address of source Interface is used for all RADIUS communications
between the RADIUS server and the RADIUS client. The selected source-interface IP address is used for filling
the IP header of RADIUS management protocol packets. This allows security devices (firewalls) to identify the
source packets coming from the specific switch.
If a source-interface is not specified, the primary IP address of the originating (outbound) interface is used as
the source address. If the configured interface is down, the RADIUS client falls back to its default behavior.
no radius source-interface
Use this command to reset the RADIUS source interface to the default settings.
Format
no radius server retransmit
Mode Global Config
Format
radius source-interface {unit/slot/port | loopback loopback-id | vlan vlan-id}
Mode Global Config
Parameter Description
unit/slot/port The unit identifier assigned to the switch.
loopback-id Configures the loopback interface. The range of the loopback ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is
1 to 4093.
Format
no radius source-interface
Mode Global Config