Command Reference Guide

TACACS+ Commands
CLI Command Reference
September 2014 Page 128
HP Moonshot Switch Module CLI Command Reference
Access Requests............................... 0.00
Access Retransmissions........................ 0
Access Accepts................................ 0
Access Rejects................................ 0
Access Challenges............................. 0
Malformed Access Responses.................... 0
Bad Authenticators............................ 0
Pending Requests.............................. 0
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
TACACS+ Commands
TACACS+ provides access control for networked devices via one or more centralized servers. Similar to RADIUS,
this protocol simplifies authentication by making use of a single database that can be shared by many clients
on a large network. TACACS+ is based on the TACACS protocol (described in RFC1492) but additionally provides
for separate authentication, authorization, and accounting services. The original protocol was UDP based with
messages passed in clear text over the network; TACACS+ uses TCP to ensure reliable delivery and a shared key
configured on the client and daemon server to encrypt all messages.
tacacs-server host
Use the tacacs-server host command in Global Configuration mode to configure a TACACS+ server. This
command enters into the TACACS+ configuration mode. The
ip-address|hostname parameter is the IP address
or hostname of the TACACS+ server. To specify multiple hosts, multiple
tacacs-server host commands can be
used.
no tacacs-server host
Use the no tacacs-server host command to delete the specified hostname or IP address. The ip-
address|hostname
parameter is the IP address of the TACACS+ server.
Format
tacacs-server host ip-address|hostname
Mode Global Config
Format
no tacacs-server host ip-address|hostname
Mode Global Config