Command Reference Guide

AutoInstall Commands
CLI Command Reference
September 2014 Page 140
HP Moonshot Switch Module CLI Command Reference
no boot host retrycount
Use this command to set the number of attempts to download a configuration file to the default value.
boot host dhcp
Use this command to enable AutoInstall on the switch for the next reboot cycle. The command does not change
the current behavior of AutoInstall and saves the command to NVRAM.
no boot host dhcp
Use this command to disable AutoInstall for the next reboot cycle.
boot host autosave
Use this command to automatically save the downloaded configuration file to the startup-config file on the
switch. When autosave is disabled, you must explicitly save the downloaded configuration to non-volatile
memory by using the
write memory or copy system:running-config nvram:startup-config command. If the
switch reboots and the downloaded configuration has not been saved, the AutoInstall process begins, if the
feature is enabled.
no boot host autosave
Use this command to disable automatically saving the downloaded configuration on the switch.
Format
no boot host retrycount
Mode Privileged EXEC
Default disabled
Format
boot host dhcp
Mode Privileged EXEC
Format
no boot host dhcp
Mode Privileged EXEC
Default disabled
Format
boot host autosave
Mode Privileged EXEC
Format
no boot host autosave
Mode Privileged EXEC