Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 148
HP Moonshot Switch Module CLI Command Reference
System Information and Statistics Commands
This section describes the commands you use to view information about system features, components, and
configurations.
show arp switch
This command displays the contents of the IP stack’s Address Resolution Protocol (ARP) table. The IP stack only
learns ARP entries associated with the management interfaces - network or service ports. ARP entries
associated with routing interfaces are not listed.
show eventlog
This command displays the event log, which contains error messages from the system. The event log is not
cleared on a system reset. The
unit is the switch identifier.
Format
show arp switch
Mode Privileged EXEC
Term Definition
IP Address IP address of the management interface or another device on the management network.
MAC Address Hardware MAC address of that device.
Interface For a service port the output is
Management. For a network port, the output is the unit/
slot/port
of the physical interface.
Format
show eventlog [unit]
Mode Privileged EXEC
Term Definition
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Note: Event log information is retained across a switch reset.