Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 163
HP Moonshot Switch Module CLI Command Reference
Example: The following information shows an example of the command output:
(Routing) #show fiber-ports optical-transceiver-info all
Link Link Nominal
Length Length Bit
50um 62.5um Rate
Port Vendor Name [m] [m] Part Number [Mbps] Rev
-------- ---------------- --- ---- ------------- ----- ----
1/0/49 HP 8 3 AXM761 10300 10
1/0/51 HP 8 3 AXM761 10300 10
1/0/52 HP 8 3 AXM761 10300 10
show mac-addr-table
This command displays the forwarding database entries. These entries are used by the transparent bridging
function to determine how to forward a received frame.
Length (50um, OM2) This value specifies link length that is supported by the transceiver while operating in
compliance with applicable standards using 50 micron multimode OM2
[500MHz*km at 850nm] fiber. A value of zero means that the transceiver does not
support 50 micron multimode fiber or that the length information must be
determined from the transceiver technology.
Length (62.5um, OM1) This value specifies link length that is supported by the transceiver while operating in
compliance with applicable standards using 62.5 micron multimode OM1 [200
MHz*km at 850nm, 500 MHz*km at 1310nm] fiber. A value of zero means that the
transceiver does not support 62.5 micron multimode fiber or that the length
information must determined from the transceiver technology
Vendor SN The vendor serial number (vendor SN) is a 16 character field that contains ASCII
characters, left-aligned and padded on the right with ASCII spaces (20h), defining the
vendor's serial number for the transceiver. A value of all zero in the 16-byte field
indicates that the vendor SN is unspecified.
Vendor PN The vendor part number (vendor PN) is a 16-byte field that contains ASCII characters,
left aligned and added on the right with ASCII spaces (20h), defining the vendor part
number or product name. A value of all zero in the 16-byte field indicates that the
vendor PN is unspecified.
BR, nominal The nominal bit (signaling) rate (BR, nominal) is specified in units of 100 MBd,
rounded off to the nearest 100 MBd. The bit rate includes those bits necessary to
encode and delimit the signal as well as those bits carrying data information. A value
of 0 indicates that the bit rate is not specified and must be determined from the
transceiver technology. The actual information transfer rate will depend on the
encoding of the data, as defined by the encoding value.
Vendor Rev The vendor revision number (vendor rev) contains ASCII characters, left aligned and
padded on the right with ASCII spaces (20h), defining the vendor's product revision
number. A value of all zero in this field indicates that the vendor revision is
unspecified.
Field Description