Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 164
HP Moonshot Switch Module CLI Command Reference
Enter all or no parameter to display the entire table. Enter a MAC Address and VLAN ID to display the table
entry for the requested MAC address on the specified VLAN. Enter the
count parameter to view summary
information about the forwarding database table. Use the
interface unit/slot/port parameter to view MAC
addresses on a specific interface.
Instead of
unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG interface. lag
lag-intf-num can also be used to specify the LAG interface where lag-intf-num is the LAG port number. Use
the
vlan vlan_id parameter to display information about MAC addresses on a specified VLAN.
The following information displays if you do not enter a parameter, the keyword all, or the MAC address and
VLAN ID.
If you enter
vlan vlan_id, only the MAC Address, Interface, and Status fields appear. If you enter the interface
unit/slot/port parameter, in addition to the MAC Address and Status fields, the VLAN ID field also appears.
Format
show mac-addr-table [{macaddr vlan_id | all | count | interface unit/slot/port | vlan
vlan_id}]
Mode Privileged EXEC
Term Definition
VLAN ID The VLAN in which the MAC address is learned.
MAC Address A unicast MAC address for which the switch has forwarding and or filtering information. The
format is 6 two-digit hexadecimal numbers that are separated by colons, for example
01:23:45:67:89:AB.
Interface The port through which this address was learned.
Interface Index This object indicates the ifIndex of the interface table entry associated with this port.
Status The status of this entry. The meanings of the values are:
• Static—The value of the corresponding instance was added by the system or a user when
a static MAC filter was defined. It cannot be relearned.
• Learned—The value of the corresponding instance was learned by observing the source
MAC addresses of incoming traffic, and is currently in use.
• Management—The value of the corresponding instance (system MAC address) is also the
value of an existing instance of dot1dStaticAddress. It is identified with interface 1/0/1. and
is currently used when enabling VLANs for routing.
• Self—The value of the corresponding instance is the address of one of the switch’s physical
interfaces (the system’s own MAC address).
• GMRP Learned—The value of the corresponding was learned via GMRP and applies to
Multicast.
• Other—The value of the corresponding instance does not fall into one of the other
categories.