Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 165
HP Moonshot Switch Module CLI Command Reference
The following information displays if you enter the count parameter:
process cpu threshold
Use this command to configure the CPU utilization thresholds. The Rising and Falling thresholds are specified
as a percentage of CPU resources. The utilization monitoring time period can be configured from 5 seconds to
86400 seconds in multiples of 5 seconds. The CPU utilization threshold configuration is saved across a switch
reboot. Configuring the falling utilization threshold is optional. If the falling CPU utilization parameters are not
configured, then they take the same value as the rising CPU utilization parameters.
Term Definition
Dynamic Address
count
Number of MAC addresses in the forwarding database that were automatically
learned.
Static Address (User-
defined) count
Number of MAC addresses in the forwarding database that were manually entered by
a user.
Total MAC Addresses
in use
Number of MAC addresses currently in the forwarding database.
Total MAC Addresses
available
Number of MAC addresses the forwarding database can handle.
Format
process cpu threshold type total rising 1-100 interval
Mode Global Config
Parameter Description
rising threshold The percentage of CPU resources that, when exceeded for the configured rising interval,
triggers a notification. The range is 1 to 100. The default is 0 (disabled).
rising interval The duration of the CPU rising threshold violation, in seconds, that must be met to trigger
a notification. The range is 5 to 86400. The default is 0 (disabled).
falling threshold The percentage of CPU resources that, when usage falls below this level for the configured
interval, triggers a notification. The range is 1 to 100. The default is 0 (disabled).
A notification is triggered when the total CPU utilization falls below this level for a
configured period of time. The falling utilization threshold notification is made only if a
rising threshold notification was previously done. The falling utilization threshold must
always be equal or less than the rising threshold value. The CLI does not allow setting the
falling threshold to be greater than the rising threshold.
falling interval The duration of the CPU falling threshold, in seconds, that must be met to trigger a
notification. The range is 5 to 86400. The default is 0 (disabled).