Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 169
HP Moonshot Switch Module CLI Command Reference
show running-config
Use this command to display or capture the current setting of different protocol packages supported on the
switch. This command displays or captures commands with settings and configurations that differ from the
default value. To display or capture the commands with settings and configurations that are equal to the
default value, include the
all option.
The output is displayed in script format, which can be used to configure another switch with the same
configuration. If the optional
scriptname is provided with a file name extension of .scr, the output is redirected
to a script file.
dir
Use this command to list the files in flash.
Note: Show running-config does not display the User Password, even if you set one different from the
default.
Note: If you issue the show running-config command from a serial connection, access to the switch
through remote connections (such as Telnet) is suspended while the output is being generated and
displayed.
Note: If you use a text-based configuration file, the show running-config command will only display
configured physical interfaces, i.e. if any interface only contains the default configuration, that
interface will be skipped from the
show running-config command output. This is true for any
configuration mode that contains nothing but default configuration. That is, the command to enter a
particular config mode, followed immediately by its exit command, are both omitted from the
show
running-config
command output (and hence from the startup-config file when the system
configuration is saved.)
Format
show running-config [all | scriptname]
Mode Privileged EXEC
Format
dir
Mode Privileged EXEC