Command Reference Guide

System Information and Statistics Commands
CLI Command Reference
September 2014 Page 170
HP Moonshot Switch Module CLI Command Reference
show running-config interface
Use this command to display the running configuration for a specific interface. Valid interfaces include physical,
LAG, loopback, tunnel and VLAN interfaces.
show sysinfo
This command displays switch information.
Format
show running-config interface {interface | lag {lag-intf-num} | loopback {loopback-
id} | vlan {vlan-id}}
Mode Privileged EXEC
Parameter Description
interface Running configuration for the specified interface.
lag-intf-num Running configuration for the LAG interface.
loopback-id Running configuration for the loopback interface.
vlan-id Running configuration for the VLAN routing interface.
Format
show sysinfo
Mode Privileged EXEC
Term Definition
Switch Description Text used to identify this switch.
System Name Name used to identify the switch.The factory default is blank. To configure the system
name, see “snmp-server” on page 100.
System Location Text used to identify the location of the switch. The factory default is blank. To
configure the system location, see “snmp-server” on page 100.
System Contact Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see “snmp-server” on page 100.
System ObjectID The base object ID for the switch’s enterprise MIB.
System Up Time The time in days, hours and minutes since the last switch reboot.
Current SNTP
Synchronized Time
The system time acquired from a network SNTP server.
MIBs Supported A list of MIBs supported by this agent.