Command Reference Guide

Warp Core Expandable Port Configuration
CLI Command Reference
September 2014 Page 175
HP Moonshot Switch Module CLI Command Reference
show interfaces hardware profile
Use the show interfaces hardware profile command to display the hardware profile information for the 40G
ports. The command displays the 40G interface and the corresponding 10G interfaces. Because any hardware
profile configuration is only effective in the next boot of the switch, the configured mode may be different than
the operational mode of the interface. Therefore, this command also displays the configured mode and the
operational mode of the interface.
You can optionally specify an interface to view.
Example: The following shows an example of the CLI display output for the command after the
hardware
profile portmode 4x10g
command has been executed on interfaces 1/1/1 and 1/1/6 and the switch has
been reset.
(Routing) #show interfaces hardware profile
Configured Oper
40G Interface 10G Interfaces Mode Mode
------------- -------------- ---------- -------
1/1/1 1/1/2-5 4x10g 4x10g
1/1/6 1/1/7-10 4x10g 4x10g
1/1/11 1/1/12-15 1x40g 1x40g
1/1/16 1/1/17-20 1x40g 1x40g
Format
show interfaces hardware profile [interface]
Mode Privileged EXEC
Field Description
40G Interface The unit/slot/port identifier of the 40G interface.
10G Interfaces The unit/slot/port identifiers of the 4 × 10G interfaces that correspond to the single
1×40G interface.
Configured Mode The mode the port is configured to operate in after the next boot cycle.
Operating Mode The mode in which the port is currently operating.