Command Reference Guide

Logging Commands
CLI Command Reference
September 2014 Page 179
HP Moonshot Switch Module CLI Command Reference
logging host remove
This command disables logging to host. See “show logging hosts” on page 182 for a list of host indexes.
logging persistent
Use this command to configure the Persistent logging for the switch. The severity level of logging messages is
specified at severity level. Possible values for severity level are (emergency|0, alert|1, critical|2, error|3,
warning|4, notice|5, info|6, debug|7).
no logging persistent
Use this command to disable the persistent logging in the switch
.
logging syslog
This command enables logging to a host where up to eight hosts can be configured.
no logging syslog
This command disables syslog logging.
Format
logging host remove hostindex
Mode Global Config
Default Disable
Format
logging persistent severity level
Mode Global Config
Format
no logging persistent
Mode Global Config
Default Port - 514, Level - Critical, Component - All
Format
logging host ipaddress component component lvl7clear
Mode Global Config
Format
no logging syslog
Mode Global Config