Command Reference Guide

Logging Commands
CLI Command Reference
September 2014 Page 182
HP Moonshot Switch Module CLI Command Reference
show logging buffered
This command displays buffered logging (system startup and system operation logs).
show logging hosts
This command displays all configured logging hosts. Use the “|” character to display the output filter options.
Example: The following shows example CLI display output for the command.
(Routing) #show logging hosts ?
<cr> Press enter to execute the command.
| Output filter options.
(Routing) #show logging hosts
Index IP Address/Hostname Severity Port Status
-------- ---------------------- ----------- ------ ---------
1 10.130.64.88 critical 514 Active
2 2000::150 critical 514 Active
Format
show logging buffered
Mode Privileged EXEC
Term Definition
Buffered (In-Memory)
Logging
Shows whether the In-Memory log is enabled or disabled.
Buffered Logging
Wrapping Behavior
The behavior of the In Memory log when faced with a log full situation.
Buffered Log Count The count of valid entries in the buffered log.
Format
show logging hosts
Mode Privileged EXEC
Term Definition
Host Index (Used for deleting hosts.)
IP Address /
Hostname
IP address or hostname of the logging host.
Severity Level The minimum severity to log to the specified address. The possible values are emergency
(0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Port The server port number, which is the port on the local host from which syslog messages are
sent.
Host Status The state of logging to configured syslog hosts. If the status is disable, no logging occurs.