Command Reference Guide

Email Alerting and Mail Server Commands
CLI Command Reference
September 2014 Page 184
HP Moonshot Switch Module CLI Command Reference
Email Alerting and Mail Server Commands
logging email
This command enables email alerting and sets the lowest severity level for which log messages are emailed. If
you specify a severity level, log messages at or above this severity level, but below the urgent severity level,
are emailed in a non-urgent manner by collecting them together until the log time expires. You can specify the
severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
no logging email
This command disables email alerting.
logging email urgent
This command sets the lowest severity level at which log messages are emailed immediately in a single email
message. Specify the
severitylevel value as either an integer from 0 to 7 or symbolically through one of the
following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug
(7). Specify
none to indicate that log messages are collected and sent in a batch email at a specified interval.
no logging email urgent
This command resets the urgent severity level to the default value.
Default disabled; when enabled, log messages at or above severity Warning (4) are emailed
Format
logging email [severitylevel]
Mode Global Config
Format
no logging email
Mode Global Config
Default Alert (1) and emergency (0) messages are sent immediately.
Format
logging email urgent {severitylevel | none}
Mode Global Config
Format
no logging email urgent
Mode Global Config