Command Reference Guide

Email Alerting and Mail Server Commands
CLI Command Reference
September 2014 Page 186
HP Moonshot Switch Module CLI Command Reference
no logging email message-type subject
This command removes the configured email subject for the specified message type and restores it to the
default email subject.
logging email logtime
This command configures how frequently non-urgent email messages are sent. Non-urgent messages are
collected and sent in a batch email at the specified interval. The valid range is every 30–1440 minutes.
no logging email logtime
This command resets the non-urgent log time to the default value.
logging traps
This command sets the severity at which SNMP traps are logged and sent in an email. Specify the
severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
no logging traps
This command resets the SNMP trap logging severity level to the default value.
Format
no logging email message-type {urgent |non-urgent |both} subject
Mode Global Config
Default 30 minutes
Format
logging email logtime minutes
Mode Global Config
Format
no logging email logtime
Mode Global Config
Default Info (6) messages and higher are logged.
Format
logging traps severitylevel
Mode Global Config
Format
no logging traps
Mode Global Config