Command Reference Guide

Email Alerting and Mail Server Commands
CLI Command Reference
September 2014 Page 187
HP Moonshot Switch Module CLI Command Reference
logging email test message-type
This command sends an email to the SMTP server to test the email alerting function.
show logging email config
This command displays information about the email alert configuration.
Format
logging email test message-type {urgent |non-urgent |both} message-body message-body
Mode Global Config
Format
show logging email config
Mode Privileged EXEC
Term Definition
Email Alert Logging The administrative status of the feature: enabled or disabled
Email Alert From Address The email address of the sender (the switch).
Email Alert Urgent Severity
Level
The lowest severity level that is considered urgent. Messages of this type are
sent immediately.
Email Alert Non Urgent Severity
Level
The lowest severity level that is considered non-urgent. Messages of this
type, up to the urgent level, are collected and sent in a batch email. Log
messages that are less severe are not sent in an email message at all.
Email Alert Trap Severity Level The lowest severity level at which traps are logged.
Email Alert Notification Period The amount of time to wait between non-urgent messages.
Email Alert To Address Table The configured email recipients.
Email Alert Subject Table The subject lines included in urgent (Type 1) and non-urgent (Type 2)
messages.
For Msg Type urgent, subject is The configured email subject for sending urgent messages.
For Msg Type non-urgent,
subject is
The configured email subject for sending non-urgent messages.