Command Reference Guide

Device Location, System Utility, and Clear Commands
CLI Command Reference
September 2014 Page 190
HP Moonshot Switch Module CLI Command Reference
show mail-server config
This command displays information about the email alert configuration.
Device Location, System Utility, and Clear Commands
This section describes the commands you use to help troubleshoot connectivity issues and to restore various
configurations to their factory defaults.
uid
Use this command to illuminate the Unit Identifier (UID) LED on the lower-left corner of the face plate (above
the Health LED). When the UID LED is on, it is blue and can help you locate the physical unit within a rack of
devices.
Format
show mail-server {ip-address | hostname | all} config
Mode Privileged EXEC
Term Definition
No of mail servers configured The number of SMTP servers configured on the switch.
Email Alert Mail Server Address The IPv4/IPv6 address or DNS hostname of the configured SMTP server.
Email Alert Mail Server Port The TCP port the switch uses to send email to the SMTP server
Email Alert Security Protocol The security protocol (TLS or none) the switch uses to authenticate with the
SMTP server.
Email Alert Username The username the switch uses to authenticate with the SMTP server.
Email Alert Password The password the switch uses to authenticate with the SMTP server.
Default Off
Format
uid {on |off}
Mode Privileged EXEC