Command Reference Guide

Device Location, System Utility, and Clear Commands
CLI Command Reference
September 2014 Page 193
HP Moonshot Switch Module CLI Command Reference
Example: traceroute Failure:
(Routing) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec 18 msec 9 msec
2 10.240.1.252 0 msec 0 msec 1 msec
3 172.31.0.9 277 msec 276 msec 277 msec
4 10.254.1.1 289 msec 327 msec 282 msec
5 10.254.21.2 287 msec 293 msec 296 msec
6 192.168.76.2 290 msec 291 msec 289 msec
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
Example: traceroute ipv6 Failure
(Routing)# traceroute 2001::2 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size 43
Traceroute to 2001::2 hops max 43 byte packets:
1 3001::1 708 msec 41 msec 11 msec
2 4001::2 250 msec 200 msec 193 msec
3 5001::3 289 msec 313 msec 278 msec
4 6001::4 651 msec 41 msec 270 msec
5 0 0 msec *
Hop Count = 4 Last TTL = 5 Test attempt = 1 Test Success = 0
clear config
This command resets the configuration to the factory defaults without powering off the switch. When you issue
this command, a prompt appears to confirm that the reset should proceed. When you enter
y, you
automatically reset the current configuration on the switch to the default values. It does not reset the switch.
clear counters
This command clears the statistics for a specified unit/slot/port, for all the ports, or for the entire switch
based upon the argument.
clear igmpsnooping
This command clears the tables managed by the IGMP Snooping function and attempts to delete these entries
from the Multicast Forwarding Database.
Format
clear config
Mode Privileged EXEC
Format
clear counters {unit/slot/port | all}
Mode Privileged EXEC
Format
clear igmpsnooping
Mode Privileged EXEC