Command Reference Guide

Simple Network Time Protocol Commands
CLI Command Reference
September 2014 Page 199
HP Moonshot Switch Module CLI Command Reference
Example: The following shows an example of downloading and applying ias users file.
(Routing) #copy tftp://10.131.17.104/aaa_users.txt ias-users
Mode........................................... TFTP
Set Server IP.................................. 10.131.17.104
Path........................................... ./
Filename....................................... aaa_users.txt
Data Type...................................... IAS Users
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
File transfer operation completed successfully.
Validating and updating the users to the IAS users database.
Updated IAS users database successfully.
Simple Network Time Protocol Commands
This section describes the commands you use to automatically configure the system time and date by using
Simple Network Time Protocol (SNTP).
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two where poll-
interval
can be a value from 6 to 10.
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Default 6
Format
sntp broadcast client poll-interval poll-interval
Mode Global Config
Format
no sntp broadcast client poll-interval
Mode Global Config