Command Reference Guide

Simple Network Time Protocol Commands
CLI Command Reference
September 2014 Page 200
HP Moonshot Switch Module CLI Command Reference
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode to either
broadcast or unicast.
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
sntp client port
This command sets the SNTP client port ID to a value from 1-65535. The default value is 0, which means that
the SNTP port is not configured by the user. In the default case, the actual client port value used in SNTP packets
is assigned by the underlying OS.
no sntp client port
This command resets the SNTP client port back to its default value.
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two where poll-interval
can be a value from 6 to 10.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
Format
no sntp client mode
Mode Global Config
Default 0
Format
sntp client port portid
Mode Global Config
Format
no sntp client port
Mode Global Config
Default 6
Format
sntp unicast client poll-interval poll-interval
Mode Global Config