Command Reference Guide

Simple Network Time Protocol Commands
CLI Command Reference
September 2014 Page 204
HP Moonshot Switch Module CLI Command Reference
show sntp server
This command is used to display SNTP server settings and configured servers.
For each configured server:
Format
show sntp server
Mode Privileged EXEC
Term Definition
Server Host Address IP address or hostname of configured SNTP Server.
Server Type Address type of server (IPv4, IPv6, or DNS).
Server Stratum Claimed stratum of the server for the last received valid packet.
Server Reference ID Reference clock identifier of the server for the last received valid packet.
Server Mode SNTP Server mode.
Server Maximum Entries Total number of SNTP Servers allowed.
Server Current Entries Total number of SNTP configured.
Term Definition
IP Address / Hostname IP address or hostname of configured SNTP Server.
Address Type Address Type of configured SNTP server (IPv4, IPv6, or DNS).
Priority IP priority type of the configured server.
Version SNTP Version number of the server. The protocol version used to query the server
in unicast mode.
Port Server Port Number.
Last Attempt Time Last server attempt time for the specified server.
Last Update Status Last server attempt status for the server.
Total Unicast Requests Number of requests to the server.
Failed Unicast Requests Number of failed requests from server.