Command Reference Guide

Simple Network Time Protocol Commands
CLI Command Reference
September 2014 Page 205
HP Moonshot Switch Module CLI Command Reference
show sntp source-interface
Use this command to display the SNTP client source interface configured on the switch.
Example: The following shows example CLI display output for the command.
(Routing) #show sntp source-interface
SNTP Client Source Interface................... (not configured)
(Routing) #
Format
show sntp source-interface
Mode Privileged EXEC
Field Description
SNTP Client Source
Interface
The interface ID of the physical or logical interface configured as the SNTP client
source interface.
SNTP Client Source IPv4
Address
The IP address of the interface configured as the SNTP client source interface.