Command Reference Guide

DNS Client Commands
CLI Command Reference
September 2014 Page 211
HP Moonshot Switch Module CLI Command Reference
ip domain list
Use this command to define a list of default domain names to complete unqualified names. By default, the list
is empty. Each name must be no more than 256 characters, and should not include an initial period. The default
domain name, configured using the
ip domain name command, is used only when the default domain name list
is empty. A maximum of 32 names can be entered in to this list.
no ip domain list
Use this command to delete a name from a list.
ip name server
Use this command to configure the available name servers. Up to eight servers can be defined in one command
or by using multiple commands. The parameter
server-address is a valid IPv4 or IPv6 address of the server. The
preference of the servers is determined by the order they were entered.
no ip name server
Use this command to remove a name server.
Default none
Format
ip domain list name
Mode Global Config
Format
no ip domain list name
Mode Global Config
Format
ip name server server-address1 [server-address2...server-address8]
Mode Global Config
Format
no ip name server [server-address1...server-address8]
Mode Global Config