Command Reference Guide

DNS Client Commands
CLI Command Reference
September 2014 Page 215
HP Moonshot Switch Module CLI Command Reference
show hosts
Use this command to display the default domain name, a list of name server hosts, the static and the cached
list of host names and addresses. The parameter
name ranges from 1-255 characters. This command displays
both IPv4 and IPv6 entries.
Example: The following shows example CLI display output for the command.
<Routing> show hosts
Host name......................... Device
Default domain.................... gm.com
Default domain list............... yahoo.com, Stanford.edu, rediff.com
Domain Name lookup................ Enabled
Number of retries................. 5
Retry timeout period.............. 1500
Name servers (Preference order)... 176.16.1.18 176.16.1.19
DNS Client Source Interface....... (not configured)
Configured host name-to-address mapping:
Host Addresses
------------------------------ ------------------------------
accounting.gm.com 176.16.8.8
Host Total Elapsed Type Addresses
--------------- -------- ------ -------- --------------
www.stanford.edu 72 3 IP 171.64.14.203
Format
show hosts [name]
Mode Privileged EXEC
User EXEC
Field Description
Host Name Domain host name.
Default Domain Default domain name.
Default Domain List Default domain list.
Domain Name Lookup DNS client enabled/disabled.
Number of Retries Number of time to retry sending Domain Name System (DNS) queries.
Retry Timeout Period Amount of time to wait for a response to a DNS query.
Name Servers Configured name servers.
DNS Client Source
Interface
Shows the configured source interface (source IP address) used for a DNS client.
The IP address of the selected interface is used as source IP for all communications
with the server.