Command Reference Guide

IP Address Conflict Commands
CLI Command Reference
September 2014 Page 216
HP Moonshot Switch Module CLI Command Reference
IP Address Conflict Commands
The commands in this section help troubleshoot IP address conflicts.
ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending gratuitous ARP packets
for IPv4 addresses on the switch.
show ip address-conflict
This command displays the status information corresponding to the last detected address conflict.
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format
ip address-conflict-detect run
Mode Global Config
Format
show ip address-conflict
Modes Privileged EXEC
Term Definition
Address Conflict Detection
Status
Identifies whether the switch has detected an address conflict on any IP
address.
Last Conflicting IP Address The IP Address that was last detected as conflicting on any interface.
Last Conflicting MAC Address The MAC Address of the conflicting host that was last detected on any
interface.
Time Since Conflict Detected The time in days, hours, minutes and seconds since the last address conflict
was detected.
Format
clear ip address-conflict-detect
Modes Privileged EXEC