Command Reference Guide

Using CLI Help
CLI Command Reference
September 2014 Page 22
HP Moonshot Switch Module CLI Command Reference
Using CLI Help
Enter a question mark (?) at the command prompt to display the commands available in the current mode.
(Routing) >?
enable Enter into user privilege mode.
help Display help for various special keys.
logout Exit this session. Any unsaved changes are lost.
ping Send ICMP echo packets to a specified IP address.
quit Exit this session. Any unsaved changes are lost.
show Display Switch Options and Settings.
telnet Telnet to a remote host.
Enter a question mark (?) after each word you enter to display available command keywords or parameters.
(Routing) #network ?
ipv6 Configure IPv6 parameters for system network.
mac-address Configure MAC Address.
mac-type Select the locally administered or burnedin MAC
address.
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the device.
protocol Select DHCP, BootP, or None as the network config
protocol.
If the help output shows a parameter in angle brackets, you must replace the parameter with a value.
(Routing) #network parms ?
<ipaddr> Enter the IP Address.
none Reset IP address and gateway on management interface
If there are no additional command keywords or parameters, or if additional parameters are optional, the
following message appears in the output:
<cr> Press Enter to execute the command
You can also enter a question mark (?) after typing one or more characters of a word to list the available
command or parameters that begin with the letters, as shown in the following example:
(Routing) #show m?
mac mac-addr-table mac-address-table
mail-server management mldsnooping
mmrp monitor mrp
mvr mvrp