Command Reference Guide

Serviceability Packet Tracing Commands
CLI Command Reference
September 2014 Page 228
HP Moonshot Switch Module CLI Command Reference
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. Use the optional receive or
transmit keywords to specify whether to enable tracing for received or transmitted packets. When neither
keyword is used in the command, then all MLD snooping packet traces are dumped. Vital information such as
source address, destination address, control packet type, packet length, and the interface on which the packet
is received or transmitted is displayed on the console.
no debug mldsnooping packet
Use this command to disable debug tracing of MLD snooping packet reception and transmission.
Default disabled
Format
debug lacp packet
Mode Privileged EXEC
Format
no debug lacp packet
Mode Privileged EXEC
Default disabled
Format
debug mldsnooping packet [receive | transmit]
Mode Privileged EXEC