Command Reference Guide

Serviceability Packet Tracing Commands
CLI Command Reference
September 2014 Page 237
HP Moonshot Switch Module CLI Command Reference
show debugging
Use the show debugging command to display enabled packet tracing configurations.
Example: The following shows example CLI display output for the command.
console# debug arp
Arp packet tracing enabled.
console# show debugging
Arp packet tracing enabled.
no show debugging
Use the no show debugging command to disable packet tracing configurations.
exception protocol
Use this command to specify the protocol used to store the core dump file.
no exception protocol
Use this command to reset the exception protocol configuration to its factory default value.
exception dump tftp-server
Use this command to configure the IP address of a remote TFTP server in order to dump core files to an external
server.
Format
show debugging
Mode Privileged EXEC
Format
no show debugging
Mode Privileged EXEC
Default None
Format
exception protocol {tftp | none}
Mode Global Config
Format
no exception protocol
Mode Global Config
Default None
Format
exception dump tftp-server {ip-address}
Mode Global Config