Command Reference Guide

Serviceability Packet Tracing Commands
CLI Command Reference
September 2014 Page 239
HP Moonshot Switch Module CLI Command Reference
no exception core-file
Use this command to reset the exception core file prefix configuration to its factory default value. The
hostname and time-stamp are disabled.
exception switch-chip-register
This command enables or disables the switch-chip-register dump in case of an exception. The switch-chip-
register dump is taken only for a master unit and not for member units
write core
Use the write core command to generate a core dump file on demand. The write core test command is
helpful when testing the core dump setup. For example, if the TFTP protocol is configured,
write core test
communicates with the TFTP server and informs the user if the TFTP server can be contacted. Similarly, if
protocol is configured as
nfs, this command mounts and unmounts the file system and informs the user of the
status.
For
write core test, the destination file name is used for the TFTP test. Optionally, you can specify the
destination file name when the protocol is configured as TFTP.
Format
no exception core-file
Mode Global Config
Default Disable
Format
exception switch-chip-register {enable | disable}
Mode Global Config
Note: write core reloads the switch which is useful when the device malfunctions, but has not
crashed.
Default None
Format
write core test [dest_file_name]]
Mode Privileged EXEC