Command Reference Guide

Stacking Commands
CLI Command Reference
September 2014 Page 24
HP Moonshot Switch Module CLI Command Reference
Section 3: Stacking Commands
This chapter describes the stacking commands available in the HP Moonshot Switch Module CLI.
The Stacking Commands chapter includes the following sections:
• “Switch Stacking” on page 24
• “Stack Port Commands” on page 33
• “Nonstop Forwarding Commands” on page 37
Switch Stacking
This section describes the commands you use to configure switch stacks.
stack
This command sets the mode to Stack Global Config.
member
This command configures a switch. The unit is the switch identifier of the switch to be added/removed from
the stack. The
switchindex is the index into the database of the supported switch types, indicating the type of
the switch being preconfigured. The switch index is a 32-bit integer. This command is executed on the Primary
Management Unit.
Note: The Primary Management Unit is the unit that controls the stack.
Format
stack
Mode Global Config
Format
member unit switchindex
Mode Stack Global Config
Note: Switch index can be obtained by executing the show supported switchtype command in User
EXEC mode.