Command Reference Guide

sFlow Commands
CLI Command Reference
September 2014 Page 246
HP Moonshot Switch Module CLI Command Reference
no sflow source-interface
Use this command to reset the sFlow source interface to the default settings.
show sflow agent
The sFlow agent collects time-based sampling of network interface statistics and flow-based samples. These
are sent to the configured sFlow receivers. Use this command to display the sFlow agent information.
Example: The following shows example CLI display output for the command.
(Routing) #show sflow agent
sFlow Version.................................. 1.3;HP;8.6.5.4
IP Address..................................... 10.27.22.133
Parameter Description
unit/slot/port VLAN or port-based routing interface.
loopback-id Configures the loopback interface to use as the source IP address. The range of the
loopback ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is
1 to 4093.
Format
no sflow source-interface
Mode Global Config
Format
show sflow agent
Mode Privileged EXEC
Field Description
sFlow Version Uniquely identifies the version and implementation of this MIB. The version string must
have the following structure: MIB Version; Organization; Software Revision where:
• MIB Version: 1.3, the version of this MIB.
• Organization: HP.
• Revision: 1.0
IP Address The IP address associated with this agent.