Command Reference Guide

sFlow Commands
CLI Command Reference
September 2014 Page 247
HP Moonshot Switch Module CLI Command Reference
show sflow pollers
Use this command to display the sFlow polling instances created on the switch. Use “-” for range.
show sflow receivers
Use this command to display configuration information related to the sFlow receivers.
Example: The following shows example CLI display output for the show sflow receivers command.
(Routing) #show sflow receivers 1
Receiver Index................................. 1
Owner String................................... tulasi
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Format
show sflow pollers
Mode Privileged EXEC
Field Description
Poller Data Source The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support
Physical ports only.
Receiver Index The sFlowReceiver associated with this sFlow counter poller.
Poller Interval The number of seconds between successive samples of the counters associated
with this data source.
Format
show sflow receivers [index]
Mode Privileged EXEC
Parameter Description
Receiver Index The sFlow Receiver associated with the sampler/poller.
Owner String The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out The time (in seconds) remaining before the receiver is released and stops sending
samples to sFlow receiver. The no timeout value of this parameter means that the
sFlow receiver is configured as a non-timeout entry.
Max Datagram Size The maximum number of bytes that can be sent in a single sFlow datagram.
Port The destination Layer4 UDP port for sFlow datagrams.
IP Address The sFlow receiver IP address.
Address Type The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
address, the value is 2.
Datagram Version The sFlow protocol version to be used while sending samples to sFlow receiver.