Command Reference Guide

Switch Stacking
CLI Command Reference
September 2014 Page 25
HP Moonshot Switch Module CLI Command Reference
no member
This command removes a switch from the stack. The unit is the switch identifier of the switch to be removed
from the stack. This command is executed on the Primary Management Unit.
switch priority
This command configures the ability of a switch to become the Primary Management Unit. The unit is the
switch identifier. The
value is the preference parameter that allows the user to specify, priority of one backup
switch over another. The range for priority
is 0 to 15. The switch with the highest priority value will be chosen
to become the Primary Management Unit if the active Primary Management Unit fails. Setting the value to 0
prevents the unit from being able to become the Management Unit. The switch priority defaults to the
hardware management preference value 1. Switches that do not have the hardware capability to become the
Primary Management Unit are not eligible for management.
switch renumber
This command changes the switch identifier for a switch in the stack. The oldunit is the current switch
identifier on the switch whose identifier is to be changed. The
newunit is the updated value of the switch
identifier. Upon execution, the switch will be configured with the configuration information for the new switch,
if any. The old switch configuration information will be retained, however the old switch will be operationally
unplugged. This command is executed on the Primary Management Unit. After issuing this command, you are
prompted to reload the unit that is being renumbered. The renumbering will not take effect until the unit is
reloaded.
Format
no member unit
Mode Stack Global Config
Default enabled
Format
switch unit priority value
Mode Global Config
Note: If the management unit is renumbered, then the running configuration is no longer applied (i.e.
the stack acts as if the configuration had been cleared).
Format
switch oldunit renumber newunit
Mode Global Config