Command Reference Guide

Switch Stacking
CLI Command Reference
September 2014 Page 26
HP Moonshot Switch Module CLI Command Reference
movemanagement
This command moves the Primary Management Unit functionality from one switch to another. The fromunit
is the switch identifier on the current Primary Management Unit. The tounit is the switch identifier on the new
Primary Management Unit. Upon execution, the entire stack (including all interfaces in the stack) is
unconfigured and reconfigured with the configuration on the new Primary Management Unit. After the reload
is complete, all stack management capability must be performed on the new Primary Management Unit. To
preserve the current configuration across a stack move, execute the
copy system:running-config
nvram:startup-config
(in Privileged EXEC) command before performing the stack move. A stack move causes
all routes and layer 2 addresses to be lost. This command is executed on the Primary Management Unit. The
system prompts you to confirm the management move.
standby
Use this command to configure a unit as a Standby Management Unit (STBY).
no standby
The no form of this command allows the application to run the auto Standby Management Unit logic.
Format
movemanagement fromunit tounit
Mode Stack Global Config
Note: The Standby Management Unit cannot be the current Management Unit. The Standby unit
should be a management-capable unit.
Format
standby unit number
Mode Stack Global Config
Parameter Description
Standby Management Unit Number Indicates the unit number which is to be the Standby Management
Unit. unit number must be a valid unit number.
Format
no standby
Mode Stack Global Config