Command Reference Guide

Remote Monitoring Commands
CLI Command Reference
September 2014 Page 260
HP Moonshot Switch Module CLI Command Reference
show rmon events
This command displays the entries in the RMON event table.
Example: The following shows example CLI display output for the command.
(Routing) # show rmon events
Index Description Type Community Owner Last time sent
-------------------------------------------------------------------------------
1 test log public MIB 0 days 0 h:0 m:0 s
show rmon history
This command displays the specified entry in the RMON history table.
Format
show rmon events
Mode Privileged Exec
Parameter Description
Index An index that uniquely identifies an entry in the event table. Each such entry defines one
event that is to be generated when the appropriate conditions occur. The range is 1 to
65535.
Description A comment describing the event entry. The default is alarmEvent.
Type The type of notification that the probe makes about the event. Possible values are None,
Log, SNMP Trap, Log and SNMP Trap. The default is None.
Community The SNMP community specific by this octet string which is used to send an SNMP trap. The
default is public.
Owner Event owner. The owner string associated with the entry.
Last time sent
The last time over which a log or a SNMP trap message is generated.
Format
show rmon history index {errors [period seconds]|other [period seconds]|throughput
[period seconds]}
Mode Privileged Exec
Parameter Description
History Control
Index
An index that uniquely identifies an entry in the historyControl table. Each such entry
defines a set of samples at a particular interval for an interface on the device. The range
is 1 to 65535.
History Control Data
Source
The source interface for which historical data is collected.
History Control
Buckets Requested
The requested number of discrete time intervals over which data is to be saved. The
range is 1 to 65535. The default is 50.