Command Reference Guide

Switch Stacking
CLI Command Reference
September 2014 Page 27
HP Moonshot Switch Module CLI Command Reference
slot
This command configures a slot in the system. The unit/slot is the slot identifier of the slot. The cardindex is
the index into the database of the supported card types, indicating the type of the card being preconfigured in
the specified slot. The card index is a 32-bit integer. If a card is currently present in the slot that is unconfigured,
the configured information will be deleted and the slot will be re-configured with default information for the
card.
no slot
This command removes configured information from an existing slot in the system.
set slot disable
This command configures the administrative mode of the slot(s). If you specify [all], the command is applied to
all slots, otherwise the command is applied to the slot identified by
unit/slot.
If a card or other module is present in the slot, this administrative mode will effectively be applied to the
contents of the slot. If the slot is empty, this administrative mode will be applied to any module that is inserted
into the slot. If a card is disabled, all the ports on the device are operationally disabled and shown as
“unplugged” on management screens.
Format
slot unit/slot cardindex
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype command in User EXEC
mode.
Format
no slot unit/slot cardindex
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype command in User EXEC
mode.
Format
set slot disable [unit/slot] | all]
Mode Global Config