Command Reference Guide

Port Configuration Commands
CLI Command Reference
September 2014 Page 273
HP Moonshot Switch Module CLI Command Reference
show port advertise
Use this command to display the local administrative link advertisement configuration, local operational link
advertisement, and the link partner advertisement for an interface. It also displays priority Resolution for
speed and duplex as per 802.3 Annex 28B.3. It displays the Auto negotiation state, Phy Master/Slave Clock
configuration, and Link state of the port.
If the link is down, the Clock is displayed as No Link, and a dash is displayed against the Oper Peer
advertisement, and Priority Resolution. If Auto negotiation is disabled, then the admin Local Link
advertisement, operational local link advertisement, operational peer advertisement, and Priority resolution
fields are not displayed.
If this command is executed without the optional
unit/slot/port parameter, then it displays the Auto-
negotiation state and operational Local link advertisement for all the ports. Operational link advertisement
will display speed only if it is supported by both local as well as link partner. If auto-negotiation is disabled,
then operational local link advertisement is not displayed.
Example: The following commands show the command output with and without the optional parameter:
(Routing)#show port advertise 1/0/1
Port: 1/0/1
Type: Gigabit - Level
Link State: Down
Auto Negotiation: Enabled
Clock: Auto
1000f 1000h 100f 100h 10f 10h
----- ----- ---- ---- --- ---
Admin Local Link Advertisement no no yes no yes no
Oper Local Link Advertisement no no yes no yes no
Oper Peer Advertisement no no yes yes yes yes
Priority Resolution - - yes - - -
(Routing)#show port advertise
Port Type Neg Operational Link Advertisement
--------- ------------------------------ ----------- ------------------------------
1/0/1 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
1/0/2 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
1/0/3 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
Link Trap This object determines whether or not to send a trap when link status changes. The factory
default is enabled.
LACP Mode LACP is enabled or disabled on this port.
Actor Timeout The configured timeout value for the LACP actor (the local LAG interface).
Format
show port advertise [unit/slot/port]
Mode Privileged EXEC
Term Definition